Custom Lead Terminations & Mountings

Standard & Custom Lead Exits and Cartridge Mountings

Lead Exit - T1
Our standard ending consists of a heat-resistant ceramic paste which seals the entry against moisture. Various remaining cartridges are made with this base, unless otherwise stated.

Lead Exit - T2: Ceramic Plug
t2C
artridge has a steatite ceramic piece which juts out slightly. It is 0.118 inches to 0.236 inches in length, depending on the diameter of the cartridge. It prevents the touching of the leads within the tube, thereby giving more consistent cable entry.

Lead Exit - T3: Block with screw Endingst3
Cartridge has a steatite ceramic piece with inserted screws. This allows for the quick attachment of any wires

Lead Exit - T4: Twin Post Endingst4
Cartridge with stainless steel imperial/metric threaded studs.  This allows for the quick changing of wires.

Lead Exit - T5: Single Cable Endingt5
Cartridge with a single fibreglass cable for low voltage cartridges

Lead Exit - T6: Single Post Endingt6
Cartridge with an imperial/metric unipolar threaded stud for a quick cable attachment.

Mounting - T7: Circular Steel Plate  and Nipple endingst7
A circular plate including mounting holes, to securely fasten the cartridge on to the object being heated.Ideal for areas subject to movement and vibration.

t7-1

N.B. Metric dimensions and bespoke sizes also available

Mounting - T7B: Steel Squared Plate and Nipple endingst7b
A squared plate with mounting hole, to  fasten the cartridge on to the object being heated, for areas subject to mild movement and vibration.

t7-2

N.B. Metric dimensions and bespoke sizes also available

Mounting & Endings - T8: Threaded Section with nut and Nipple terminationst8
Fully water resistant (IP67) and reinforced cartridge. Ready for removal from its application by unscrewing, especially if the cartridge has become dislodged.

Ideal for areas where pressurised fluids are present. This is useful for heating in areas with pressure fluids(oil & water tanks, glues, plastics etc.) and even incinerators

t7-3

N.B. Metric dimensions and bespoke sizes also available

Mounting - T9: Metal Block with 90º tube exit and cablet9
Fully water resistant (IP67) and highly reinforced cartridge with a metal block and armoured and sealed cable.Its strong reinforcement is to prevent deformation in case of major displacement of the cartridge. The finished T9 can be used in any hostile situation (including fluids,high temperatures,shocks and impacts).

t9-1

N.B. Metric dimensions and bespoke sizes also available

Cartridge leads with simple orifice exit at 90º. Ref: T9B.t9b

t9-2N.B. Metric dimensions and bespoke sizes also available

Cartridge leads exit at 90º within tubular protection. Ref: T9 PB. Also available T9 PBE as right-angle tube spliced at the end of the cartridge.t9c

 

 

t9-2N.B. Metric dimensions and bespoke sizes also available

Cartridge leads exit within a right angle elbow. Ref: T9CAt9a

 

 

t9-3N.B. Metric dimensions and bespoke sizes also available

Custom Enquiry Form

Do you require a specific heater - then give us a call

loctite LB 8065

Copyright © 2017 Lojer Components. All rights reserved.
Site developed by ITsECPC